You may remember my post talking about Cedar and Mr. Stanley.  Here's the end result.  I started out with 3/4" cedar boards, gotten from a local Amish furniture maker.  I rough cut them down to size, then planed the sides and edges to smoothness.  I used a 4' brass piano hinge on the door, along with a nice little wooden knob for the door I found at Home Depot.  The door is held shut with two latches, much like you'd use on a screen door.  There's 8 brass cup hooks for hanging the rods to dry, a 1 3/8" hole on the top for the heat to escape (1 3/8" was the only Forstner bit I had larger than 1/2"....).  The light fixture is just a standard porcelain ceiling light fixture, with a 200 watt bulb.  The bottom inside is just aluminum foil, glued in place with 3M 77 adhesive.  Sure does make the workshop smell nice!